Description
Microphone Input | Balance X2R socket to receive various low level microphone signals | ||
Line Input | Non- balanced socket,receiving various unbalanced or balanced high level voice tip signals. |
||
Channel Peak Display | When the channel signal is clipped due to too high lift, the indicator lights up to prompt DJ to make adjustment |
||
Gain Control | Adjust this knob to increase or decrease channel level from -60db to -16db |
||
Channel Signal Switch | Press this key to attenuate the channel signal by 20dB. | ||
Treble Control | Adjust the knob to control channel treble tone. | ||
If Tone Control | Adjust the knob to control the channel mid range tone. | ||
Bass Control | Adjust the knob to control the channel bass tone | ||
Auxiliary Knob | Adjust the auxiliary knob to enter the specified equipment as required for the channel signal,without affecting the mixed amplification signal. |
||
Insert Adjustment For Internal Effect |
Adjust the knob to allow the channel signal to enter the effector. | ||
Balance Control | Adjust knob , can make the left , in the channel distribution as required , make it to deal stereo effect. | ||
Channel Monitering switch |
Press this button, the channel can be monitored by headphones. | ||
Channel Volume Attenuation Driver |
Adjust the push, can control the channel signal size, to match the overall performance. | ||
Main Output Section | |||
Output status display | It can be used to display the main channel out put directly and make the adjustment reach the ideal state |
||
Internal Balance | The equalizer can adjust each frequency band according to the needs in order to achieve ideal syllables. |
||
Stereo main sound Attenuation promoter |
By adjusting the driver, you can make the main output level meet the ideal requirement state. |
||
Internal Effect Monitoring Section |
|||
Recording Out PUT Knob | Adjust the knob, you can adjust the size of recording signal as needed, to the ideal state. | ||
Auxiliary Send Level Adjustment | The level of the control auxiliary send is turned off to the interface of the external calling device. | ||
Auxiliary Return Level Regulation | Control the return level of the external signal, and reach the ideal state of the mixing of the generator signal and main channel signal. | ||
Signal Adjustment For Internal Effect | Adjust the knob so that the input signal can be added to the effector as required. | ||
Digital Effect Display | Adjust UP and DOWN buttons to achieve ideal reverb effect state according to your needs. This function displays 16 levels effect state for adjustment. | ||
Loop Back Adjustment Of Internal Effect | By adjusting the knob, the loop signal of the internal effect can reach the ideal state. | ||
Internal Effect Balance Control | Adjust the knob, can make the effect in the machine according to the requirments of distribution, into the left , right sound channel. | ||
Internal Effect Monitoring Switch | Press the button to use the effect signal in the earphone monitor. | ||
In Machine Effect Attenuation Push | By adjusting the driver , you can control the output level of the effect signal. | ||
Headphone Monitor Volume Adjustment | By adjusting the knob, the volume of the head phone can be adjusted. | ||
Headphone Socket | Stereo headphone connection jack can monitor the output of stereo, mono, marshalling and first output channel. | ||
Bluetooth | Bluetooth receiver | ||
Rear Panel | |||
power switch | |||
Speaker Out | 4 speaker outs 2 mono and 2 speakon outs | ||
PMS-6BLT USB | Channel |
|
|
Power RMS WATTS | 350Wx2=700W | ||
Power pmpo watts | 750WX2=1500W | ||
Total Harmonic Distortion |
0.1% below (1KHX Full Power) | ||
Power Requirements | AC 220/50Hz or 120V/60Hz | ||
Impedance | 8Ω |